RARE user and assistance email list

[mc36 <>]

hi,
if it was a standalone switch then yess, but as we're playing with 
stack/multichassis/linecard-based/whatever we call it for a while,
the backplane stuff alone involves mpls because regular bridging is expressed 
internally as vpls (and basic routing as mpls vpn)...
where the inner label is the regular service label and the outer label is 
identifying a member of the stack...
br,
cs

On 6/1/22 11:42, Xavier Jeannin wrote:
> Hello Csaba,
>
> What about "profile-renater-peering-l2.p4" and 
> "profile-renater-peering-l2.tmpl" ?
> Can we use it form bridging performance test ?
>
> Regards
> Xavier
>
> Le 01/06/2022    10:06, mc36 a   crit  :
> > hi,
> > two things:
> > 1) the lab was recently reconfigured to be a stack of poz-bud-fra-ams...
> >      if you want to configure any ports of these four, please perform it at
> >      netops@rare-bastion-86-7968c4d54f-qkv2x:~$ ctrl-rare
> > 2) the current active profile is geant-testbed at all of these which
> >      does not include bridging... you can set the profile individually,
> >      let's say just on POZ0001#tna-set-profile <capitalized name from>
> > https://bitbucket.software.geant.org/projects/RARE/repos/rare/browse/profiles,
> >      but, right now, we don't have anything with bridging and mpls both 
> > enabled...
> >      i'll add a vpls profile asap but i'll take some time until it goes 
> > through
> >      the release processes... (imho it should be out by next monday...)
> > br,
> > cs
> >
> >
> >
> > On 6/1/22 09:51, Tomasz Szewczyk wrote:
> > > Hi,
> > >
> > > I'm trying to make RFC2889 address learning/caching tests on poz-rare
> > >
> > > I have bridge defined with ports:
> > > POZ0001#show bridge 3
> > > packet                             byte
> > > iface                     fwd         phys     tx     rx     drop     tx     
> > > rx     drop grp
> > > brprt bvi
> > > sdn4                         true     true     0         0         0          
> > >        0         0 0
> > > sdn6                         true     true     0         0         0          
> > >        0         0 0
> > > sdn7                         true     true     0         0         0          
> > >        0         0 0
> > >
> > >
> > >                                                                               
> > >      packet byte
> > > addr     iface     static     time       tx     rx     drop     tx     rx     
> > > drop
> > >
> > > But there's no traffic.
> > > Interfaces are configred this way:
> > >
> > > POZ0001#sh run int sdn4
> > > interface sdn4
> > >      description POZ0001@31/0 -> SPIRENT@PSCN-#1
> > >      mtu 2000
> > >      macaddr 0031.645a.1c09
> > >      lldp enable
> > >      cdp enable
> > >      bridge-group 3
> > >      no shutdown
> > >      no log-link-change
> > >      exit
> > > !
> > >
> > > Do I need any specific configuration for that?
> > >      I'm sending just untagged frames from the tester.
> > >
> > > br
> > > Tomek