cat-users AT lists.geant.org
Subject: The mailing list for users of the eduroam Configuration Assistant Tool (CAT)
List archive
- From: Lars Rökaeus <lars.rokaeus AT gu.se>
- To: Tomasz Wolniewicz <twoln AT umk.pl>
- Cc: cat-users AT geant.net
- Subject: Re: [cat-users] Test of Wired Ethernet configurations
- Date: Wed, 4 Nov 2015 09:53:08 +0100
- List-archive: <https://mail.geant.net/mailman/private/cat-users/>
- List-id: "The mailing list for users of the eduroam Configuration Assistant Tool \(CAT\)" <cat-users.geant.net>
Tomasz,
On Tue, 3 Nov 2015, Tomasz Wolniewicz wrote:
> instead for checking for the obvious, I started checking if CAT
> Windows installers work properly - they do, however the one for
> University of Gothenburg does not have the wired option set.
Correct. Wired option is now disabled. It was enabled during the test.
> To enable it you need to go into the IdP settings and within the Media
> properties you need to add the "Configure Wired Ethernet" option and select
> the checkbox which will appear. When you save the settings the installers
> should have the wired option enabled. Windows installers will now require
> admin rights to run, as they may need to start the .1x configuration service
> on user's system.
All these conditions were fullfilled during the test. The size of the
installer
increased. The installer prompted about wired interface configuration. The
installer started the .1x configuration service (Wired AutoConfig).
But I needed to set (mark) "Specify authentication mode":
Start; Control Panel; Network and Sharing Center;
Change adaper setting; Local Area Connection; Right click;
Properties; Authentication; Additional Settings;
Mark: Specify authentication mode; OK; OK;
> W dniu 2015-10-29 o 15:10, Lars Rökaeus pisze:
> > I have tested two eduroam CAT intallers with "wired ethernet" for
> > University of Gothenburg (Idp=595) some weeks ago.
> >
> > Problems which I meet:
> > Linux installer had no "wired ethernet" support
> > Windows 7 installer must then be manually configered with:
> > Start; Control Panel; Network and Sharing Center;
> > Change adaper setting; Local Area Connection; Right click;
> > Properties; Authentication; Additional Settings;
> > Mark: Specify authentication mode; OK; OK;
> > Am I doing something wrong?
Regards
--
/ Lars Rökaeus IT-enheten, Göteborgs universitet
-------------------------------------------------------
E-mail:<lars.rokaeus AT gu.se>
Tel:+46-31 7865354
- Re: [cat-users] Test of Wired Ethernet configurations, Tomasz Wolniewicz, 11/03/2015
- Re: [cat-users] Test of Wired Ethernet configurations, Lars Rökaeus, 11/04/2015
Archive powered by MHonArc 2.6.19.