RARE user and assistance email list

[Frédéric LOUI <>]

Not sure this is a typo but dav0001 has sdn7.6666 (=VLAN 6666)
While the other interface have 666.

Maybe you can with plain interface without VLAN.

Some useful commands:
show ipv4 arp <intf> -> in order to check L2 operation
show ipv6 nei <intf> -> in order to check L2 operation
show lldp nei (granted that lldp is enabled)
ping /repeat <x> /time 11 used with debug ipv4 icmp / term mon in order to 
check if packet are received (echo request) 
On the other end and if you have response. (Echo reply)

Can you send us config with: show running-config hide ?
(In order to share private key and password) not a big deal it was the 
opportunity to demonstrate this command.

> Le 23 févr. 2022 à 09:44, Xavier Jeannin <> a 
> écrit :
> 
> Dear All, 
> 
> I tried to implement a simple switch layer 2 based on a Wedge.on the  
> schema attached you can see that the Wedge is connected to 2 DPDK- Dell 
> Machines also running RARE-FreeRtr
> 
> In the different step off the configuration, on interface of DPDK- Dell 
> Machines went down and it is impossible to bring it up. 
> I use basic command to debug this. 
> 
> As beginner, I would like to have advise on which things I have to check ? 
> Which commands are useful ? 
> How to check how RARE-FreeRtr see the SFP ? any physical parameters  that I 
> can check?
> I recall that there is also a correspondence between the port in 
> RARE-FreeRtr and DPDK at system level (if I am not wrong) ?
> 
> Thank you
> Xavier
> 
> 
> <Kh04Rn8q4NBxYMPL.png>
> 
> -- 
> Xavier JEANNIN
> Network Dpt. - Innovation manager
> GN4-3 Network technology evolution (WP6 T1) task leader
> Tél. : +33 1 5394 2042
> Mob. : +33 6 3017 0963
> 
> www.renater.fr