Rare project developers

[mc36 <>]

yess you can set it...
br,
cs

noti#configure
noti(cfg)#interface loopback0
noti(cfg-if)#router ospf4 1 ?
  area              - specify area number
  authen-id         - id for authentication
  authen-type       - mode for authentication
  bfd               - enable bfd triggered down
  bier              - bier parameters
  cost              - interface cost
  dead-time         - time before neighbor down
  dynamic-algo      - calculation to do
  dynamic-divisor   - divide result
  dynamic-ignore    - ignore small differences
  dynamic-maximum   - highest result
  dynamic-metric    - dynamic peer metric
  dynamic-minimum   - lowest result
  dynamic-multiply  - multiply result
  dynamic-size      - number of measurement
  dynamic-skip-max  - discard big measures
  dynamic-skip-min  - discard small measures
  dynamic-time      - measurement interval
  enable            - enable protocol processing
  hello-time        - time between hellos
  instance          - interface instance
  neighbor          - specify static neighbor
  network           - specify network type
  passive           - do not process packets 
<----------------------------------------
  password          - password for authentication
  priority          - router priority
  retransmit-time   - time before retarnsmitting
  segrout           - segment routing parameters
  suppress-prefix   - do not advertise interface
  traffeng          - traffic engineering parameters
  unsuppress-prefix - do advertise interface
  verify-source     - check source address of updates

noti(cfg-if)#router ospf4 1


On 12/16/22 09:11, Maria Del Carmen Misa Moreira wrote:
> Hi,
>
> I would like to configure OSPF passive in one interface but I didn   t find 
> this option in freeRtr and I   m sure that it   s possible to do it.
> Any idea?
>
> Thanks in advance,
> Cheers,
> Carmen Misa