Rare project developers

[mc36 <>]

hi,
so these vpdns should point to the eth1's ip of the gcloud node, assuming 
that ip is public or at least reachable to the clients...
if you want to make that private addressed loopback on the gcloud node 
reachable to the clients then you'll have to add the
client config knobs to the gcloud node itselt too... btw please note that 
this sdwan server just creates a bunch of l2tp
back and forth between the clients (marked as hub).. to move further, you'll 
need to run a routing protocol above these...
feel free to use the following as an example: 
http://sources.freertr.org/cfg/serv-sdwan01.tst
to run it locally on your computer, you can do the following:
wget freertr.org/rtr.zip
unzip rtr.zip
cd src
./c.sh
./tw.sh serv-sdwan01
afterward all the above, you can reach the router described in the test case 
by
telnet localhost 20001
telnet localhost 20002
telnet localhost 20003
telnet localhost 20004
br,
cs


On 7/11/22 16:56, Edgard da Cunha Pontes wrote:
> Hi everyone!
>
> While I was testing RARE/freeRtr's SD-WAN functionality, the following (noob) 
> question came up:
>
> On client VMs, how to point to a loopback interface, on VM/GCloud (SD-WAN 
> server) that is behind an associated public IP? I was in doubt which target I 
> should put in the vpdn settings.
>
> I made a basic description of the settings I am using:
>
> https://github.com/edgardcunha/freeRouter/tree/main/sdwan/01 
> <https://github.com/edgardcunha/freeRouter/tree/main/sdwan/01>
>
> I hope this basic description can help you to understand this doubt.